Author Archives: mz12gt

Interior – Paint

Posted on January 8, 2012 by mz12gt

I want to absolutely minimize the chances of getting new rust, so I am painting the interior of the car with Wattyl KillRust Heavy Duty Primer and the over coating with Wattyl Kill Rust Epoxy.

Posted in Work | Tagged , , | Leave a comment

Assembly – Head – Part II

Posted on December 17, 2011 by mz12gt

Getting ready to finish reassembling the head. Checking the cam housing fitment. Painted and cleaned parts in the backyard. Rocker arms marinating in kerosene.

Posted in Assembly, Cleaned | Tagged , , , , , | Leave a comment

Multivision Computer

Posted on December 11, 2011 by mz12gt

The MZ12 Multivision Computer is made up of 3 component boxes TW-D611T (86116-24010) which is responsible for multiplexing the video signal together using AN5315 and AN5352 chips. TW-D603T (86010‑24010) which is the television tuner box. TW-D604T (86112‑24010) which is the … Continue reading →

Posted in Parts | Tagged , , , | Leave a comment

Assembly – Head – Part I

Posted on December 10, 2011 by mz12gt

I installed the engine head. Using ARP head studs and nuts.

Posted in Assembly | Tagged , , , , | Leave a comment

Assembly – Timing Cover and Oil Pan

Posted on December 10, 2011 by mz12gt

On the 3rd attempt I managed to install the front timing cover with new oil seals. Using the FEL-PRO TCS455181 Kit and 7MGE crankshaft oil seal. I used Hylomar on the gaskets. It’s fiddly stuff but is supposed to work … Continue reading →

Posted in Assembly | Tagged , , , , , , | Leave a comment

Assembly – Boot

Posted on December 7, 2011 by mz12gt

Started putting the boot back together. Selection of tail lights.

Posted in Uncategorized | Tagged , , | Leave a comment

Blank Canvas

Posted on December 6, 2011 by mz12gt

Pulled off the bonnet and stored it until it is ready to go back on. A blank canvas.

Posted in Assembly | Tagged , , | Leave a comment

Assembly – Timing Cover

Posted on December 2, 2011 by mz12gt

Cleaned Timing Cover with new water pump, seals and hardware. To installed this weekend hopefully without over-torquing the gasket this time.

Posted in Assembly, New | Tagged , , , , | Leave a comment

Block – Assembly

Posted on October 15, 2011 by mz12gt

So today I attempted for the second time to assemble the engine block. The first time I tried I broke a piston ring meaning that I had to order a whole new set of the things. The 2 most important … Continue reading →

Posted in Assembly | Tagged , , , , , | Leave a comment

From the Panel Shop

Posted on September 27, 2011 by mz12gt

All the panel work and painting is now completed. It is painted two-tone in the Toyota X52 colour scheme. The work was done by Andy’s Restorations. All that needs to be done now is for me to reassemble everything.

Posted in Work | Leave a comment